PYLE Audio Headphones PLVWH2 User Manual

WIRELESS INFRARED TRANSMITTER AND  
WIRELESS INFRARED STEREO HEADPHONE  
LVWH2  
 
Precautions  
* Operate the transmitter on 12V 100mA. Operate the headphone  
system on3V DC (size AAAbatteries x 2).  
* Turn off the power of the transmitter and the system is not in use.  
* Do not open the cabinet. Refer servicing to qualified personnel  
only.  
* Do not leave the system in a location near heat sources such as  
radiators or airducts, or in a place subject to direct sunlight,  
excessive dust, moisture, rain, mechanical vibrantion, or shock.  
* Do not use alcohol, benzine or thinner to clean the cabinet.  
Transmitter  
1. Infrared emitter  
2. Audio input ( R) RED  
1
3. Audio input ( L) WHITE  
4. Power 12VDC (+)RED  
(-)BLACK  
4
2
3
Velcrofor Mounting  
IR Transmitter  
Headphone  
1. Infrared sensors  
2. Power Switch  
3. Stereo / mono  
4. Volume Controls  
5. Battery Compartment Door  
6. Ear pad  
7. Adjustableheadband  
IR Stereo Headphone  
1. Open the battery compartment door on the right of the  
headphone.  
2. Insert two size AAAbatteries with correct polarity.  
3. Close the battery compartment.  
2
 
How to use  
1. Turn on the audio/video equipment  
connected to the transmitter.  
2. Turn on the power switch for  
headphone.  
4. Turn on the stereo switch for  
stereo effect. For Mono  
3. Adjust volume control on the  
left side. Do not cover the sensors  
while adjusting volumes.  
audio/video equipment, turn  
the switch to the mono position.  
5. Receiving Positions  
The headphone / Receiver receives audio signals omni-directionally  
and in line-of-sight within certain effective ranges.  
For best reception, use th headphone. within 5 meters from the emitter  
of the transmitter.  
Specifications:  
* Infrared Wave-Lenght: 850mm  
* Modulation: Frequency Modulation  
* Carrier Frequency: L-ch ---- 2.3 MHz  
R-ch ---- 2.80 MHz  
Transmitter:  
* Input Voltage: 12 VDC +-2V  
* Current: <80mA  
* IF Frequency: L-ch --- 2.3 MHz +-15KHz  
R-ch --- 2.80 MHz +-15KHz  
* Impedance: 10K ohm +-15%  
* Auto. On Lever: Less Than 30 mV (input: 1KHz)  
* Auto. Off Time: 120 Sec - 240 Sec  
* Connecting Pin Wiring Source: (1) Ground (2) Left Ch (3) Right Ch.  
(4) GND (5) +12V  
3
 

Philips Car Video System CED1700 User Manual
Philips CRT Television TP3675 User Manual
Philips DVD Recorder DVDR5350H User Manual
Philips Electric Toothbrush HX6733 User Manual
Philips Fryer AJ130 User Manual
Pitco Frialator Fryer SEH50 User Manual
Porter Cable Drill 23 8300 56 User Manual
Porter Cable Portable Generator A02871 043 0 User Manual
Poulan Pole Saw MCP1510 User Manual
Powermate Portable Generator PL0495503 User Manual