Philips Portable Speaker BT1300 User Manual

Always there to help you  
Register your product and get support at  
BT1300  
Question?  
Contact  
Philips  
User manual  
 
1 Important  
Warning  
Never remove the casing of this speaker.  
Never lubricate any part of this speaker.  
Never place this speaker on other electrical equipment.  
Keep this speaker away from direct sunlight, naked  
flames or heat.  
Make sure that there is enough free space  
around the speaker for ventilation.  
Only use attachments or accessories  
specified by the manufacturer.  
The battery shall not be exposed to  
excessive heat such as sunshine, fire or the  
like.  
The speaker shall not be exposed to  
dripping or splashing.  
Do not place any sources of danger on  
the speaker (e.g. liquid filled objects, lighted  
candles).  
Note  
The type plate is located on the back of the product.  
2
EN  
 
 
2 Your Bluetooth  
speaker  
Congratulations on your purchase, and  
welcome to Philips!To fully benefit from the  
support that Philips offers, register your product  
Introduction  
With this speaker, you can enjoy audio from  
your Bluetooth-enabled devices, or other  
external audio devices.  
What's in the box  
Check and identify the contents of your  
package:  
Speaker  
USB cable for charging  
String for carrying  
Short user manual  
Safety and notice leaflet  
Always there to help you  
Register your product and get support at  
Question?  
Contact  
Philips  
Short user manual  
EN  
3
 
     
Overview of the speaker  
a
b
c
d
e
a LED indicator  
b
Disconnect Bluetooth connection.  
Enter Bluetooth pairing mode.  
Answer or reject an incoming call.  
End the current phone call.  
Transfer the call to your mobile device.  
c DC IN  
Recharge the built-in battery with a  
USB cable.  
d AUDIO IN  
Connect an external audio device.  
e OFF/AUDIO IN/  
Select Bluetooth or AUDIO IN source.  
Turn the speaker off.  
4
EN  
 
 
3 Get started  
Always follow the instructions in this chapter in  
sequence.  
Attach the string  
DC IN  
For easy carrying, attach the supplied string to  
this speaker as illustrated.  
Charging indicator status  
The LED indicator indicates the battery status.  
Under charging Fully charged  
"OFF"  
Flashing white  
Off  
mode  
"AUDIO  
IN" mode  
Flashing white  
Solid white  
"Bluetooth" Flashing blue  
Flashing blue  
or solid blue  
(depending  
on Bluetooth  
connection  
status)  
mode  
or solid blue  
(depending  
on Bluetooth  
connection  
status)  
Charge the built-in battery  
The speaker is powered by a built-in  
rechargeable battery.  
Turn on/off  
To turn the speaker on, slide the  
Note  
OFF/AUDIO IN/ switch to or AUDIO  
IN.  
Before use, fully charge the built-in battery.  
The micro USB socket is for charging only.  
Rechargeable battery has a limited number of charge  
cycles. Battery life and number of charge cycles vary by  
use and settings.  
: Listen to an external Bluetooth  
device through Bluetooth connection.  
AUDIO IN: Listen to an external  
device through an audio input cable.  
To turn the speaker off, slide the switch to  
OFF.  
Connect the supplied USB cable between  
the DC IN socket on the speaker, and  
a USB socket of a computer.  
EN  
5
 
       
To disconnect the Bluetooth-enabled device:  
4 Play  
Press and hold  
for two seconds;  
Disable Bluetooth on your device; or  
Move the device beyond the  
communication range.  
» The LED indicator flashes blue.  
Use Bluetooth devices  
To reconnect the Bluetooth device:  
Next time you turn on the speaker, the  
speaker will reconnect the last connected  
device automatically; or  
On your Bluetooth device, select "Philips  
BT1300" on your Bluetooth menu to start  
pairing.  
With this speaker, you can listen to audio from  
Bluetooth-enabled devices and control the  
incoming call through Bluetooth.  
Play from Bluetooth devices  
To connect another Bluetooth-enabled device:  
Note  
1 Press and hold  
for two seconds to  
Make sure that your Bluetooth device is compatible  
with this speaker.  
Before pairing a device with this speaker, read its user  
manual for Bluetooth compatibility.  
disconnect the currently connected device;  
» The speaker enters Bluetooth pairing  
mode.  
The speaker can memorize a maximum of 4 paired  
devices.  
Make sure that Bluetooth function is enabled on your  
device, and your device is set as visible to all other  
Bluetooth devices.  
Any obstacle between this speaker and a Bluetooth  
device can reduce the operational range.  
Keep away from any other electronic device that may  
cause interference.  
2 Connect another Bluetooth device.  
LED indicator  
Description  
Flashing blue  
Connecting;  
Waiting for pairing  
Solid blue  
Connected  
The operational range between this speaker and a  
Bluetooth device is approximately 10 meters (30 feet).  
If there is an incoming call on the connected mobile  
phone, music playback pauses.  
Control your phone call  
After Bluetooth connection, you can control an  
incoming call with this speaker.  
1 Slide the OFF /AUDIO IN/ switch to .  
» The LED indicator flashes blue.  
Button Function  
2 On your Bluetooth device, enable  
Bluetooth and search for Bluetooth devices  
that can be paired (refer to the user  
manual of the device).  
Press to answer an incoming call.  
Press and hold to reject an incoming  
call.  
During a call, press to end the current  
call.  
3 When [Philips BT1300] is displayed on  
your device, select it to start pairing and  
connection. If necessary, input “0000” as  
the pairing password.  
During a call, press and hold to  
transfer the call to your mobile device.  
» After successful pairing and connection,  
the speaker beeps twice, and the LED  
indicator turns solid blue.  
Note  
Music play pauses when there is an incoming call, and  
resumes when your phone call ends.  
4 Play audio on the Bluetooth device.  
» Audio streams from your Bluetooth  
device to the speaker.  
6
EN  
 
   
Play from external devices  
With this speaker, you can also listen to an  
external audio device such as an MP3 player.  
1 Connect an audio input cable (not  
supplied) with a 3.5 mm connector on  
both ends to  
the AUDIO IN socket on this speaker,  
and  
the headphone socket on the external  
device.  
AUDIO-IN  
2 Slide the OFF /AUDIO IN/ switch to  
AUDIO IN.  
» The LED indicator becomes white.  
3 Play audio on the external device (refer to  
its user manual).  
Adjust volume  
During play, use the volume control on your  
Bluetooth or external device to adjust volume.  
EN  
7
 
   
General information  
Power Supply  
(through USB socket)  
Built-in Battery  
5 Product  
information  
5V 0.5 A  
Li-polymer battery  
(3.7V, 500 mAh)  
55 x 55 x 55 mm  
Note  
Dimensions - Main Unit  
(W x H x D)  
Weight - Main Unit  
Product information is subject to change without prior  
notice.  
0.1 kg  
Specifications  
Amplifier  
Rated Output Power  
Frequency Response  
Signal to Noise Ratio  
Audio-in Input  
2 W RMS  
80 -16000 Hz, ±3 dB  
>70 dBA  
300 mV RMS  
Speakers  
Speaker Impedance  
Speaker Driver  
Sensitivity  
4 ohm  
4.5 cm full range  
>81dB/m/W±3dB/  
m/W  
Bluetooth  
BluetoothVersion  
V3.0  
Bluetooth Profile  
HFP, HSP,A2DP  
Bluetooth Frequency 2.4 GHz ~ 2.48 GHz  
Brand  
Bluetooth Range  
10 m (Free space)  
8
EN  
 
   
The paired device connects and disconnects  
constantly.  
6 Troubleshooting  
The Bluetooth reception is poor. Move the  
device closer to this product or remove  
any obstacle between them.  
Warning  
For some devices, Bluetooth connection  
may be deactivated automatically as a  
power-saving feature.This does not indicate  
any malfunction of this product.  
Never remove the casing of this device.  
To keep the warranty valid, never try to repair  
the system yourself.  
If you encounter problems when using this  
device, check the following points before  
requesting service. If the problem remains  
unsolved, go to the Philips Web page (www.  
philips.com/support).When you contact Philips,  
make sure that the device is nearby and the  
model number and serial number are available.  
General  
No power  
Recharge your speaker.  
No sound or poor sound  
Adjust volume on the connected device.  
No response from the speaker  
Restart the speaker.  
About Bluetooth device  
The audio quality is poor after connection  
with a Bluetooth-enabled device.  
The Bluetooth reception is poor. Move the  
device closer to this product or remove  
any obstacle between them.  
Cannot connect with the device.  
The Bluetooth function of the device is not  
enabled. Refer to the user manual of the  
device for how to enable the function.  
This product is already connected with  
another Bluetooth-enabled device.  
Disconnect that device and then try again.  
Fail to search out BT1300 on your device for  
pairing.  
Press and hold  
then try again.  
for three seconds, and  
EN  
9
 
     
be disposed of with normal household waste.  
We strongly advise you to take your product to  
an official collection point or a Philips service  
centre to have a professional remove the  
rechargeable battery.  
Inform yourself about the local separate  
collection system for electrical and electronic  
products and rechargeable batteries. Follow  
local rules and never dispose of the product  
and rechargeable batteries with normal  
household waste. Correct disposal of old  
products and rechargeable batteries helps  
prevent negative consequences for the  
environment and human health.  
7 Notice  
Any changes or modifications made to this  
device that are not expressly approved by  
WOOX Innovations may void the user’s  
authority to operate the equipment.  
Compliance  
Caution  
Hereby,WOOX Innovations declares that this  
product is in compliance with the essential  
requirements and other relevant provisions  
of Directive 1999/5/EC.You can find the  
Declaration of Conformity on www.philips.com/  
Removal of the built-in battery invalidates the warranty  
and may destroy the product.  
Always bring your product to a professional to  
remove the built-in battery.  
A
Care of the environment  
Disposal of your old product and battery  
Your product is designed and manufactured  
with high quality materials and components,  
which can be recycled and reused.  
This symbol on a product means that the  
product is covered by European Directive  
2012/19/EU.  
Environmental information  
All unnecessary packaging has been omitted.  
We have tried to make the packaging easy to  
separate into three materials: cardboard (box),  
This symbol means that the product contains  
a built-in rechargeable battery covered by  
European Directive 2013/56/EU which cannot  
10 EN  
 
     
polystyrene foam (buffer) and polyethylene  
(bags, protective foam sheet.)  
Your system consists of materials which can  
be recycled and reused if disassembled by  
a specialized company. Please observe the  
local regulations regarding the disposal of  
packaging materials, exhausted batteries and old  
equipment.  
Trademark notice  
The Bluetooth® word mark and logos are  
registered trademarks owned by Bluetooth  
SIG, Inc. and any use of such marks by WOOX  
Innovations is under license.  
EN 11  
 
 
2014 ©WOOX Innovations Limited.All rights reserved.  
Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V.  
and are used byWOOX Innovations Limited under license from Koninklijke Philips N.V.  
BT1300_00_UM_V2.0  
 

Peavey Music Mixer 64 User Manual
Peavey Music Mixer XR 800F User Manual
Peavey Stereo Amplifier IPA 150T User Manual
Philips Blu ray Player BDP2985 User Manual
Philips Cell Phone PSA[CD12 User Manual
Philips Power Supply 3R12LS1A User Manual
Pioneer CD Player CDS P4000 User Manual
Pioneer Stereo Amplifier PRS A900 User Manual
Planet Technology Cable Box SVC2540 User Manual
Poulan Lawn Mower 181223 User Manual